TECHNICAL INFORMATION
1. Create a layer of at least 5 cm of gravel (diam. 3/6 mm) on the existing substrate. Level the surface with a straightedge and check the flatness.
2. Place the slabs dry on the gravel and check that the gap between them is the same over the entire laying surface. Tap down gently with a rubber hammer to settle them into place and eliminate any unevenness.
3. Check the flatness of the surface created. Add gravel in the joints to level the paving. Decorative gravel larger in diameter than the type use for the substrate can also be used in the joints.
THE ADVANTAGES
- Inspectable, can house wiring and pipes
- three types of support
- Creates smooth surface on uneven ground
- Good drainage and insulation
© 2022 ITALGRANITI GROUP S.P.A.
Via Radici in Piano, 355
41043 Formigine - Modena - Italy
C.F. / P.IVA 03294200369
Tel: +39 059 888411 - Fax: +39 059 848808
This email address is being protected from spambots. You need JavaScript enabled to view it.
