TECHNICAL INFORMATION
1. Clean the existing surface and check that the screed has been properly prepared: flat, dry and cured. Spread the adhesive evenly over the surface.
2. Put the slabs in place and tap down gently with a rubber hammer to drive out the air and ensure perfect bonding. Fit the 4/5 mm spacers into the joints.
3. Once the glue has dried, remove the spacers, grout the joints and clean thoroughly to remove any residues.
benefits
- Drive-over for cars
- Does not absorb dirt from oil or tyres
- High pressure jet cleaning posible
- Requires a concrete screed and professional laying
© 2022 ITALGRANITI GROUP S.P.A.
Via Radici in Piano, 355
41043 Formigine - Modena - Italy
C.F. / P.IVA 03294200369
Tel: +39 059 888411
Fax: +39 059 848808
This email address is being protected from spambots. You need JavaScript enabled to view it.
Via Statuto 21
20121 Milano - Italy
tel: +39 0284567687
This email address is being protected from spambots. You need JavaScript enabled to view it.
